User's Guide

Redpine Signals, Inc. Proprietary and confidential Page 8
RS9110
-
N
-
11
-
02
Evaluation
Board
User Guide
Version 1.41
2: Wi-Fi Data Transfer Tests
The evaluation kit allows you to carry out WLAN data transfer tests, where in
RS9110-N-11-02 EVB can be connected to any 802.11bgn Access Points and
user can run any network applications to verify the WLAN connection. You can
also evaluate the application level throughputs using this EVB.
In order to perform these tests, a Windows XP, or Linux, or Window CE based
WLAN driver is provided along with the evaluation kit.
2.1: Test Setup
If you want to evaluate the system, you need to have following test setup.
The EVB is inserted into the Laptop that has SDIO slot, and it is wirelessly
connected to an 802.11n Access Point. Data transfer tests can be performed
using any other systems in the LAN, which is connected to AP. The test setup
is shown in the figure below. The sub-net mask of the wireless interface on
the Laptop and AP should be same as that of the LAN, for which AP is
connected via Ethernet.
Please note that, in order to evaluate the Lite-Fi™ on a Windows CE or a
Windows Mobile platform, you need to replace the Laptop in the following
setup, with any of the Windows CE or Windows Mobile based SDIO platform.
Laptop
with SDIO slot
802.11n
Access Point
RS9110-N-11-02
EVB
SDIO
Ethernet
LAN
Figure 4: Test Setup for Throughput Measurement
The following is the list of the test setup requirements:
• Laptop with SDIO slot and Windows XP or Linux operating system, or a
Windows CE or Windows Mobile based SDIO platform.
• RS9110-N-11-02 EVB
• 802.11n Access Point