Install Guide

8
before you begin
CAUTIONS
a) Carefully read the Installation Guide before installing this
product. If anything is unclear please contact Mentor
Engineering for support.
b) Ensure that the NEGATIVE battery connection is disconnect-
ed before beginning work.
NOTE: Some components may lose short-term memory (i.e.
engine or transmission adaptive parameters, and radio pre-
sets) after a protracted time without battery power.
c) Ranger should be serviced by qualified, trained personnel
only. Attempting to remove the cover or disassemble the
device could expose you to dangerous high voltage points.
d) Only use a damp cloth for cleaning. Never use any type of
liquid/aerosol cleaner or any type of organic solvent to clean
this product.
e) Do not attempt to install or operate a damaged device. If the
unit has been exposed to excessive amounts of water; shows
evidence of physical damage; or is not operating properly;
unplug it from the power source and contact qualified service
personnel.
f) Use of thread-locking compounds such as Loctite may cause
serious damage to plastic enclosures. Many thread-locking
compounds are not compatible with thermoplastics and can
lead to stress cracking. This will require the unit to be re-
turned to replace the ABS enclosures.
ENSURE THAT YOU HAVE ALL OF THE ITEMS LISTED IN
THE PARTS LIST