Install Guide

22
ConneCTion poinTs
6) EMERGENCY SWITCH (OPTIONAL)
The emergency switch is usually installed somewhere that
would allow for covert operation. This location needs to
be chosen by the customer prior to the start of installa-
tion. Mentor will provide a switch if one is required. It is
sometimes possible to use an existing switch already on the
vehicle. Ranger 4.0 requires a normally closed momentary
push button switch with one side connected to the blue
wire (or the wire corresponding to Pin 14 ) on the Ranger
Power Pigtail input/output cable (Part Number 4-CAS-PIGT-
VEHC24-45_R05).
Emergency Switch
Figure 8
The emergency switch is typically installed on the lower left
side of the driver seat.
Always ensure that the connector on the emergency switch
pigtail is strain reliefed off the floor to prevent shorts if water
enters the connector.