User's Manual

7
TRADE SECRET. Trapeze Proprietary and Confidential. © 2013 Trapeze Software ULC, its subsidiaries and affiliates. All rights reserved.
MOUNTING LOCATIONS
Placement
1. Ensure that the driver’s view of the road will not be impacted.
2. Ensure that the equipment will not be in the path of any active airbags.
3. Ensure that the driver will still have access to all controls on the dash.
4. Ensure that the driver has a clear view of the terminal from the seated
driving position.
5. Ensure that the terminal is within easy reach of the driver from the seated
driving position.
6. Ensure that the mounting location is a solid surface. Locations that allow even
small amounts of initial movement will loosen over time.
7. Before drilling any holes or using screws, check for vehicle wiring under the
carpet or behind the instrument panel which could be pinched, cut or otherwise
damaged.
8.Ifmountingthroughtheoor,putbodysealerovertheunderbodyprojections.
Stampedacornnuts,lledwithsealer,areavailableatmostbodyshopsfor
this purpose. This will keep moisture out of the carpet and insulation and will
forestall rust in this area.
9. If mounting under the instrument panel, be sure that there is no interference
with proper operation of the foot controls.
10. Inquire if the vehicle will be cleaned with a high pressure water wand. If so,
ensure that all equipment is installed somewhere that will be protected from
this type of cleaning.