User's Guide

Redpine Signals, Inc. Proprietary and confidential Page 13

RS9110

Evaluation

Board

User Guide

Version 1.41

S. No Signal Names Connector Pin No.

13) RF_LDO_en J8.14

14) Uart_cts J8.15

15) Xtal_ip_en J8.16

16) Power_gate_en J8.18

17) Gnd J8.17,19&20

3.3: SD Memory Interface

S.No. Signal Names Connector Pin No.

1) CS J9.1

2) DI J9.2

3) Supply J9.3

4) SCLK J9.4

5) GND J9.5

6) DO J9.6

7) CD J9.6

4: Regulatory Information

4.1: Portability Of Module

FCC Caution: Any changes or modifications not expressly approved by the

party responsible for compliance could void the user’s authority to operate

this equipment

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

This device is intended only for OEM integrators under the following

conditions.

1) The transmitter module may not be co-located with any other transmitter

or antenna

As long as condition above is met, further transmitter test will not be

required. However, the OEM integrator is still responsible for testing their end

product for any addition compliance requirements required with this module