User's Manual

MultiConnectHardwareInstallationGuide 1_2.doc
April 8, 2004
Page 9 of 17
Suite 230, 2891 Sunridge Way NE, Calgary Alberta, T1Y 7K7
♦ Phone: [phone] ♦ Fax: [phone]
2 MultiConnect Mounting Plate
The Mounting Plate is supplied with each unit, and allows the MultiConnect to be mounted
in a variety of locations and orientations. The mounting location is application specific.
The MultiConnect does not have an interactive user interface and thus can be installed
out of sight (i.e. under a car seat, or in the trunk). Installing the MultiConnect out of sight
not only increases the aesthetic properties of the installation but also limits the access by
drivers and passengers to the cabling.
The Mounting plate is first fastened to the car interior using bolts or other appropriate
means. Hardware has not been supplied for this step as it will vary depending on the
thickness and type of material the mounting plate is attached to. The MultiConnect unit
can then be attached to the mounting plate using the supplied thumbscrews.
5.1200" 6.5000"4.0000"
1.7500"
2.7750"
5.8750"
Figure 1: Mounting Plate Dimensions
Mounting Hardware:
• Mounting Plate and Thumbscrews (supplied)
• Mounting Plate Hardware (not supplied)
4 x 0.17” Mounting Holes (Fits most #8 fasteners)