Operation Manual

VLAN Commands
VLAN Commands
6 – 81
See Also
● clear security l2-restrict on page 6-68
● clear security l2-restrict counters on page 6-69
● set security l2-restrict on page 6-72
show tunnel
Displays the tunnels from the MX where you type the command.
Syntax show tunnel
Defaults None.
Access Enabled
History Introduced in MSS Version 1.0.
Examples To display all tunnels from an MX to other switches in the Mobility Domain, type the
following command.
MX# show tunnel
VLAN Local Address Remote Address State Port LVID RVID
--------------- --------------- --------------- ------- ----- ----- -----
vlan-eng 192.168.14.2 192.168.14.4 DORMANT 1024 4096 130
Table 6– 16 describes the fields in the display.
See Also show vlan config on page 6-81
show vlan config
Displays VLAN information.
Syntax show vlan config [vlan-id]
Defaults None.
Table 6– 16. Output for show tunnel
Field Description
VLAN VLAN name.
Local Address IP address of the local end of the tunnel. This is the MX IP address where you enter the
command.
Remote Address IP address of the remote end of the tunnel. This is the system IP address of another MX
in the mobility domain.
State Tunnel state:
❑ Up
❑ Dormant
Port Tunnel port ID.
LVID Local VLAN ID.
RVID Remote VLAN ID.
vlan-id VLAN name or number. If you do not specify a VLAN,
information for all VLANs is displayed.