Operation Manual

Port Commands
Port Commands
5 – 65
13 13 down - disabled off
14 14 down - disabled off
15 15 down - disabled off
16 16 down - disabled off
17 17 down - disabled off
18 18 down - disabled off
19 19 down - disabled off
20 20 down - disabled off
21 21 down - disabled invalid
22 22 down - disabled invalid
Table 5– 9 describes the fields in this display.
See Also set port poe on page 5-57
show port preference
Deprecated in MSS Version 4.0
show port status
Displays configuration and status information for ports.
Syntax show port status [port-list]
Defaults None.
Access All.
Table 5– 9. Output for show port poe
Field Description
Port Port number.
Name Port name. If the port does not have a name, the port number is
listed.
Link status Link status of the port:
❑ up—The port is connected.
❑ down—The port is not connected.
Port type Port type:
❑ MP—The port is an MP access port.
❑ - (The port is not an MP access port.)
PoE config PoE state:
❑ enabled
❑ disabled
PoE Draw Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled, this field
displays off. For gigabit Ethernet ports, this field displays invalid,
because PoE is not supported on gigabit Ethernet ports.
The value overcurrent indicates a PoE problem such as a short in the
cable.
port-list List of physical ports. If you do not specify a port list, information is displayed
for all ports.