Operation Manual

Port Commands
Mobility System Software Command Reference Guide
Version 7.3
5 – 64
● set port media-type(deprecated) on page 5-55
show port mirror
Displays the port mirroring configuration.
Syntax show port mirror
Defaults None.
Access Enabled.
History Introduced in MSS Version 4.2.
Examples The following command displays the port mirroring configuration on the MX:
MX# show port mirror
Port 1 is mirrored to port 2
If port mirroring is not configured, the message in the following example is displayed instead:
MX# show port mirror
No ports are mirrored
See Also
● clear port mirror on page 5-46
● set port mirror on page 5-55
show port poe
Displays status information for ports with Power over Ethernet (PoE) enabled.
Syntax show port poe [port-list]
Defaults None.
Access All.
History Introduced in MSS Version 1.0.
Examples The following command displays PoE information for all ports on a 22-port MX:
MX# show port poe
Link Port PoE PoE
Port Name Status Type config Draw(Watts)
===============================================================================
1 1 up - disabled off
2 2 down - disabled off
3 3 down - disabled off
4 4 down - disabled off
5 5 down - disabled off
6 6 down - disabled off
7 7 down - disabled off
8 8 down - disabled off
9 9 up MP enabled 1.44
10 10 up - disabled off
11 11 down - disabled off
12 12 down - disabled off
port-list List of physical ports. If you do not specify a port list, PoE information is
displayed for all ports.