Operation Manual

Boot Prompt Commands
Mobility System Software Command Reference Guide
Version 7.3
25 – 536
test
Displays or changes the state of the poweron test flag. The poweron test flag controls whether an
MX performs a set of self tests prior to the boot process.
Syntax test [ON | on | OFF | off]
Defaults The poweron test flag is disabled by default.
Access Boot prompt.
History Introduced in MSS Version 1.0.
Examples The following command displays the current setting of the poweron test flag:
boot> test
The diagnostic execution flag is not set.
See Also boot on page 25-526
version
Displays version information for the MX hardware and boot code.
Syntax version
Defaults None.
Access Boot prompt.
History Introduced in MSS Version 1.0.
Usage This command does not list the system image file versions installed in the boot partitions.
To display system image file versions, use the dir or fver command.
Examples To display hardware and boot code version information, type the following command at
the boot prompt:
boot> version
Trapeze Networks MX Bootstrap/Bootloader
Version 1.6.5 Release
Bootstrap 0 version: 1.17 Active
Bootloader 0 version: 1.6.5 Active
Bootstrap 1 version: 1.17
Bootloader 1 version: 1.6.3
MX Board Revision: 3.
MX Controller Revision: 24.
POE Board Revision: 1
POE Controller Revision: 6
See Also
● dir on page 25-530
● fver on page 25-531
ON Enables the poweron test flag.
on Same effect as ON.
OFF Disables the poweron test flag.
off Same effect as OFF.