Operation Manual

Boot Prompt Commands
Mobility System Software Command Reference Guide
Version 7.3
25 – 530
Syntax dhcp [ON | on | OFF | off]
Defaults The DHCP option is disabled by default.
Access Boot prompt.
History Introduced in MSS Version 1.0.
Examples The following command displays the current setting of the DHCP option:
boot> dhcp
DHCP is currently enabled.
The following command disables the DHCP option:
boot> dhcp
DHCP is currently disabled.
See Also boot on page 25-526
diag
Accesses the diagnostic mode.
Syntax diag
Defaults The diagnostic mode is disabled by default.
Access Boot prompt.
History Introduced in MSS Version 1.0.
Usage Access to the diagnostic mode requires a password, which is not user configurable. Use
this mode only if advised to do so by Trapeze Networks.
dir
Displays the boot code and system image files on an MX switch.
Syntax dir [c: | d: | e: | f: | boot0 | boot1]
Defaults None.
Access Boot prompt.
History Introduced in MSS Version 1.0.
ON Enables the DHCP option.
on Same effect as ON.
OFF Disables the DHCP option.
off Same effect as OFF.
c: Nonvolatile storage area containing boot partition 0 (primary).
d: Nonvolatile storage area containing boot partition 1 (secondary).
e: Primary partition of the flash card in the flash card slot.
f: Secondary partition of the flash card in the flash card slot.
boot0 Boot partition 0.
boot1 Boot partition 1.