Operation Manual

File Management Commands
Mobility System Software Command Reference Guide
Version 7.3
21 – 500
History
Usage
If you do not use one of the optional parameters, configuration commands that set
nondefault values are displayed for all configuration areas. If you specify an area, commands are
displayed for that area only. If you use the all option, the display also includes commands for
configuration items that are set to the default values.
Examples The following command shows configuration information for VLANs:
MX# show config area vlan
# Configuration nvgen'd at 2004-5-21 19:36:48
# Image 3.0.0
# Model MX
# Last change occurred at 2004-5-21 18:20:50
set vlan 1 port 1
See Also
● load config on page 491
● save config on page 495
show version
Displays software and hardware version information for an MX and, optionally, for any attached
MPs.
Syntax show version [details]
Defaults None
Access All.
History
Version 1.0 Command introduced
Version 2.1 New comment added to the comments at top of the file, to list the model number
Version 3.0
❑ New options added for area:
• radio-profile
• rfdevice
• service-profile
❑ rf-detection option removed. (Use rfdevice instead.)
Version 4.0
❑ New options added for remote traffic monitoring: snoop
❑ rfdevice changed to rfdetect
Version 4.1 New options added: l2acl, network-domain, and qos
Version 4.2 Option portgroup renamed to port-group for consistency with clear port-group,
set port-group, and show port-group commands.
Version 7.0 Added the options cluster and local to support Virtual Controller Cluster
configuration.
details Includes additional software build information and information about the MP
configured on the MX.
Version 1.0 Command introduced
Version 2.1 Label of Port field in detailed display modified to Port/DAP