Operation Manual

File Management Commands
Mobility System Software Command Reference Guide
Version 7.3
21 – 498
History
Examples The following command shows the boot information for an MX:
MX# show boot
Configured boot version: 4.1.0.65
Configured boot image: boot1:mx040100.020
Configured boot configuration: file:configuration
Backup boot configuration: file:backup.cfg
Booted version: 4.1.0.65
Booted image: boot1:mx040100.020
Booted configuration: file:configuration
Product model: MX
Table 21– 2 describes the fields in the show boot output.
See Also
● clear boot config on page 485
● reset system on page 493
● set boot configuration-file on page 496
● show version on page 500
Version 1.0 Command introduced
Version 1.1 The following fields were removed because they are not applicable in 1.1:
❑ Last boot status
❑ Unpacking status
Version 2.1
❑ New field, Product model, added
Version 4.1
❑ New fields, Configured boot version and Backup boot configuration, added
Table 21– 2. Output for show boot
Field Description
Configured boot version Software version the MX runs when the software is
rebooted.
Configured boot image Boot partition and image filename MSS uses to boot
when the software is rebooted.
Configured boot
configuration
Configuration filename MSS uses to boot when the
software is rebooted.
Backup boot configuration The name of the configuration file to be used in the
event that MSS cannot read the configured boot
configuration file next time the software is rebooted.
Booted version Software version the MX is running.
Booted image Boot partition and image filename MSS used the last
time the software was rebooted. MSS is running this
software image.
Booted configuration Configuration filename MSS used to load the
configuration the last time the software was rebooted.