Operation Manual
File Management Commands
File Management Commands
21 – 497
History
Usage
The file must be located in the MX nonvolatile storage.
Examples
The following command sets the boot configuration file to testconfig1:
MX# set boot configuration-file testconfig1
success: boot config set.
set boot partition
Specifies the boot partition in which to look for the system image file following the next system
reset, software reload, or power cycle.
Syntax
set boot partition {boot0 | boot1}
Defaults
By default, an MX uses the same boot partition for the next software reload that was
used to boot the currently running image.
Access
Enabled.
History
Introduced in MSS Version 1.1.
Usage
To determine the boot partition used to load the currently running software image, use the
dir command.
Examples
The following command sets the boot partition for the next software reload to partition
1:
MX# set boot partition boot1
success: Boot partition set to boot1.
See Also
● copy on page 485
● dir on page 488
● reset system on page 493
show boot
Displays the system image and configuration filenames used after the last reboot and configured
for use after the next reboot.
Syntax
show boot
Defaults
None.
Access
Access.
Version 1.0 Command introduced
Version 3.0 Subdirectory support added, to load a configuration file from a subdirectory
boot0 Boot partition 0.
boot1 Boot partition 1.