Operation Manual

File Management Commands
File Management Commands
21 – 495
success: restore complete.
See Also backup on page 483
rmdir
Removes a subdirectory from nonvolatile storage.
Syntax rmdir [subdirname]
Defaults None.
Access Enabled.
History Introduced in MSS Version 3.0.
Usage MSS does not allow the subdirectory to be removed unless it is empty. Delete all files from
the subdirectory before attempting to remove it.
Examples The following example removes subdirectory corp2:
MX# rmdir corp2
success: change accepted.
See Also
● dir on page 488
● mkdir on page 492
save config
Saves the running configuration to a configuration file.
Syntax save config [filename]
Defaults By default, MSS saves the running configuration as the configuration filename used
during the last reboot.
Access Enabled.
History
Usage
If you do not specify a filename, MSS replaces the configuration file loaded during the most
recent reboot. To display the filename of the configuration file MSS loaded during the most recent
reboot, use the show boot command.
The command completely replaces the specified configuration file with the running configuration.
subdirname Subdirectory name. Specify between 1 and 32 alphanumeric characters, with no
spaces.
filename Name of the configuration file. Specify between 1 and 128 alphanumeric characters,
with no spaces.
To save the file in a subdirectory, specify the subdirectory name, followed by a forward
slash, in front of the filename. For example: backup_configs/config_c.
Version 1.0 Command introduced
Version 3.0 Subdirectory support added, to save the configuration file to a subdirectory