Operation Manual

File Management Commands
File Management Commands
21 – 485
See Also
● set boot backup-configuration on page 496
● show boot on page 497
clear boot config
Resets to the factory default the configuration that MSS loads during a reboot.
Syntax clear boot config
Defaults None.
Access Enabled.
History Introduced in MSS Version 1.0.
Examples The following commands back up the configuration file on an MX, reset the switch to its
factory default configuration, and reboot the MX:
MX# copy configuration tftp://10.1.1.1/backupcfg
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
MX# clear boot config
success: Reset boot config to factory defaults.
MX# reset system force
...... rebooting ......
See Also
● reset system on page 493
● show config on page 499
copy
Performs the following copy operations:
● Copies a file from a FTP or TFTP server to nonvolatile storage.
● Copies a file from nonvolatile storage or temporary storage to a FTP or TFTP server.
● Copies a file securely using SCP (Secure Copy Protocol).
● Copies a file from one area in nonvolatile storage to another.
● Copies a file to a new filename in nonvolatile storage.