Operation Manual
RF Detection Commands
Mobility System Software Command Reference Guide
Version 7.3
20 – 480
See Also
● show rfdetect data on page 20-475
● show rfdetect visible on page 20-480
show rfdetect ssid-list
Displays the entries in the permitted SSID list.
Syntax
show rfdetect ssid-list
Defaults
None.
Access
Enabled.
History
Introduced in MSS Version 4.0.
Examples
The following example shows the permitted SSID list on MX:
MX# show rfdetect ssid-list
Total number of entries: 3
SSID
-----------------
mycorp
corporate
guest
See Also
● clear rfdetect ssid-list on page 20-463
● set rfdetect ssid-list on page 20-469
show rfdetect vendor-list
Deprecated in MSS Version 6.2.
show rfdetect visible
Displays the BSSIDs discovered by a specific Trapeze radio. The data includes BSSIDs
transmitted by other Trapeze radios as well as by third-party access points.
Syntax
show rfdetect visible mac-addr
Syntax
show rfdetect visible ap apnum [radio {1 | 2}]
SSID SSID mapped to the BSSID.
mac-addr Base MAC address of the Trapeze radio.
Note: To display the base MAC address of a Trapeze
radio, use the show ap status command.
apnum Port connected to the MP access point to display neighboring
BSSIDs.
Table 20– 7. show rfdetect mobility-domain ssid or bssid Output (continued)
Field Description