Operation Manual

RF Detection Commands
Mobility System Software Command Reference Guide
Version 7.3
20 – 468
Syntax set rfdetect ssid-masquerade [rogue | skip-test]
Defaults None
Access Enabled
History Introduced in MSS 6.2
Examples To configure MSS to detect unknown devices and classify them as rogue devices, use
the following command:
MX>
set rfdetect classification ssid-masquerade rogue
set rfdetect countermeasures
Deprecated in MSS Version 4.0.
set rfdetect countermeasures mac
Deprecated in MSS Version 4.0.
set rfdetect ignore
Deprecated in MSS Version 7.0.
set rfdetect log
Disables or reenables generation of log messages when rogues are detected or when they
disappear.
Syntax set rfdetect log {enable | disable}
Defaults RF detection logging is enabled by default.
Access Enabled.
History Introduced in MSS Version 3.0.
Usage The log messages for rogues are generated only on the seed and appear only in the seed’s
log message buffer. Use the show log buffer command to display the messages in the seed
switch’s log message buffer.
Examples The following command enables RF detection logging for the Mobility Domain managed
by this seed switch:
MX-20# set rfdetect log enable
success: rfdetect logging is enabled.
See Also show log buffer on page 24-520
rogue
Sets the classification as rogue.
skip-test
Sets the default classification as suspect.
enable Enables logging of rogues.
disable Disables logging of rogues.