Operation Manual

RF Detection Commands 20 – 461
20
RF Detection Commands
MSS automatically performs RF detection scans on enabled and disabled radios to detect rogue
access points. A rogue access point is a BSSID (MAC address associated with an SSID) that does
not belong to a Trapeze device and is not a member of the ignore list configured on the seed MX of
the Mobility Domain.
MSS can issue countermeasures against rogue devices to prevent clients from being able to use
them.
You can configure RF detection parameters on individual MX switches.
This chapter presents RF detection commands alphabetically. Use the following table to locate
the commands in this chapter based on usage.
Rogue Information show rfdetect clients on page 20-472
show rfdetect mobility-domain on page 20-477
show rfdetect data on page 20-475
show rfdetect visible on page 20-480
show rfdetect counters on page 20-474
Countermeasures show rfdetect countermeasures on page 20-473
Classification set rfdetect classification ad-hoc on page 20-466
set rfdetect classification default on page 20-467
set rfdetect classification seen-in-network on page
20-467
set rfdetect classification ssid-masquerade on
page 20-467
Permitted Vendor List set rfdetect vendor-list on page 20-470
show rfdetect vendor-list on page 20-480
clear rfdetect vendor-list on page 20-464
Permitted SSID List set rfdetect ssid-list on page 20-469
show rfdetect ssid-list on page 20-480
clear rfdetect ssid-list on page 20-463
Client Black List set rfdetect black-list on page 20-465
set rfdetect black-list dynamic on page 20-466
New show rfdetect black-list on page 20-471
clear rfdetect black-list on page 20-462
Rogue List clear rfdetect rogue-list on page 20-462
show rfdetect rogue-list on page 20-471
clear rfdetect rogue-list on page 20-462
Ignore List set rfdetect ignore on page 20-468
show rfdetect neighbor-list on page 20-476
clear rfdetect neighbor-list on page 20-463
MP Signatures set rfdetect signature on page 20-469