Operation Manual

Port Commands
Mobility System Software Command Reference Guide
Version 7.3
5 – 52
History Introduced in MSS Version 1.0.
Usage The reset command disables the port link and PoE (if applicable) for at least 1 second, then
reenables them. This behavior is useful for forcing an MP that is connected to two MX switches to
reboot over the link to the other MX.
Examples The following command resets port 5:
MX# reset port 5
See Also set port on page 5-54
set ap
Configures an MP, either directly connected to the MX or indirectly connected through an
intermediate Layer 2 or Layer 3 network.
Syntax set ap apnum serial-id serial-ID
model {2330 | 2330A | 2330B | 2332-A1 |AP-EASYA | AP1602 | AP1602C | AP2750 | AP3750 |
AP3850 | AP3950 | AP9551 |MP-371 | MP-371B | MP-372 | MP-372-JP| MP-372A | MP-372B |
MP-422 | MP-422A | MP-422B| MP-422FB |MP-422F|MP-432 | MP-432F | MP-522 | MP-522E
|MP-620 | MP-620A | MP-620B | MP-622 | MP-632 | MP-632F | MP-71| MP-82} [radiotype
{11a | 11b| 11g | 11na | 11ng}]
Note:
Before configuring a Distributed MP, you must use the set system countrycode
command to set the IEEE 802.11 country-specific regulations on the MX switch. See set
system countrycode on page 4-30.
apnum Number for the Distributed MP.
The range of valid connection numbers depends on the MX model:
❑ MX-200—1 to 320
❑ MX-216—1 to 320
❑ MX-400—1 to 300
❑ MX-20—1 to 100
❑ MX-8—1 to 30
❑ MXR-2—1 to 8
serial-id serial-ID MP access point serial ID. The serial ID is listed on the MP case.
To display the serial ID using the CLI, use the show version
details command.
model {2330 | 2330A | 2330B|
2332-A1 | AP1602 | AP1602C |
AP2750 | AP3750 | AP3850 |
AP3950 | MP-371 | MP-372 |
MP-372-JP |MP-372A | MP-422 |
MP-422A| MP-422F | MP-432|
MP-620 | |MP-620A | MP-622|
MP-82| MP-71}}
MP access point model.
radiotype 11a | 11b | 11g Radio type:
❑ 11a—802.11a
❑ 11b—802.11b
❑ 11g—802.11g
❑ 11na—802.11na
❑ 11ng—802.11ng
Note: This option applies only to single-radio models.