Operation Manual

802.1X Management Commands
802.1X Management Commands
18 – 445
set dot1x timeout supplicant
Sets the number of seconds that must elapse before the MX switch times out an authentication
session with a supplicant (client).
Syntax set dot1x timeout supplicant seconds
Defaults The default is 30 seconds.
Access Enabled.
History Introduced in MSS 1.0.
Examples Type the following command to set the number of seconds for authentication session
timeout to 300:
MX# set dot1x timeout supplicant 300
success: dot1x supplicant timeout set to 300.
See Also
● clear dot1x timeout auth-server on page 18-438
● show dot1x on page 18-447
set dot1x tx-period
Sets the number of seconds that must elapse before the MX switch retransmits an EAPoL packet.
Syntax set dot1x tx-period seconds
Defaults The default is 5 seconds.
Access Enabled.
History Introduced in MSS 1.0.
Examples Type the following command to set the number of seconds before the MX retransmits an
EAPoL packet to 300:
MX# set dot1x tx-period 300
success: dot1x tx-period set to 300.
See Also
❑ clear dot1x tx-period on page 18-439
❑ show dot1x on page 18-447
set dot1x unicast-rekey
Enables or disables unicast periodic rekeying on the network.
Syntax set dot1x unicast-rekey {enable | disable}
Defaults None
Access Enabled
History Introduced in MSS 7.1
seconds Specify a value between 1 and 65,535.
seconds Specify a value between 1 and 65,535.