Operation Manual

802.1X Management Commands
802.1X Management Commands
18 – 437
Examples Type the following command to reset the wired authentication port control:
MX# clear dot1x port-control
success: change accepted.
See Also
● set dot1x port-control on page 18-442
● show dot1x on page 18-447
clear dot1x quiet-period
Resets the quiet period after a failed authentication to the default setting.
Syntax clear dot1x quiet-period
Defaults The default is 60 seconds.
Access Enabled.
History Introduced in MSS 1.0.
Examples Type the following command to reset the 802.1X quiet period to the default:
MX# clear dot1x quiet-period
success: change accepted.
See Also
● set dot1x quiet-period on page 18-442
● show dot1x on page 18-447
clear dot1x reauth-max
Resets the maximum number of reauthorization attempts to the default setting.
Syntax clear dot1x reauth-max
Defaults The default is 2 attempts.
Access Enabled.
History Introduced in MSS 1.0.
Examples Type the following command to reset the maximum number of reauthorization attempts
to the default:
MX# clear dot1x reauth-max
success: change accepted.
See Also
● set dot1x reauth-max on page 18-443
● show dot1x on page 18-447
clear dot1x reauth-period
Resets the time period that must elapse before a reauthentication attempt, to the default time
period.
Syntax clear dot1x reauth-period
Defaults The default is 3600 seconds (1 hour).