Operation Manual

802.1X Management Commands
Mobility System Software Command Reference Guide
Version 7.3
18 – 436
clear dot1x bonded-period
Resets the Bonded Auth period to its default value.
Syntax clear dot1x max-req
Defaults The default bonded authentication period is 0 seconds.
Access Enabled.
History Introduced in MSS Version 2.1.
Usage
Examples
To reset the Bonded period to its default, type the following command:
MX# clear dot1x bonded-period
success: change accepted.
See Also
● set dot1x bonded-period on page 18-440
● show dot1x on page 18-447
clear dot1x max-req
Resets to the default setting the number of Extensible Authentication Protocol (EAP) requests
that the MX switch retransmits to a supplicant (client).
Syntax clear dot1x max-req
Defaults The default number is 20.
Access Enabled.
History Introduced in MSS 1.0.
Examples To reset the number of 802.1X requests the MX can send to the default setting, type the
following command:
MX# clear dot1x max-req
success: change accepted.
See Also
● set dot1x max-req on page 18-441
● show dot1x on page 18-447
clear dot1x port-control
Resets all wired authentication ports on the MX to default 802.1X authentication.
Syntax clear dot1x port-control
Defaults By default, all wired authentication ports are set to auto and they process
authentication requests as determined by the set authentication dot1X command.
Access Enabled.
History Introduced in MSS 1.0.
Usage This command is overridden by the set dot1x authcontrol command. The clear dot1x
port-control command returns port control to the method configured. This command applies only
to wired authentication ports.