Operation Manual

802.1X Management Commands 18 – 435
18
802.1X Management Commands
Use 802. IEEE X management commands to modify the default settings for IEEE 802.1X sessions
on an MX. For best results, change the settings only if you are aware of a problem with 802.1X
performance on the MX.
This chapter presents 802.1X commands alphabetically. Use the following table to locate
commands in this chapter based on their use. For information about configuring 802.1X
commands for user authentication, see Chapter , “AAA Commands,” on page 147.
!
Caution
802.1X parameter settings are global for all SSIDs configured on the MX.
Wired Authentication
Port Control
set dot1x port-control on page 18-442
clear dot1x port-control on page 18-436
set dot1x authcontrol on page 18-439
Keys set dot1x key-tx on page 18-440
set dot1x tx-period on page 18-445
clear dot1x tx-period on page 18-439
set dot1x wep-rekey on page 18-446
set dot1x wep-rekey-period on page 18-446
Bonded Authentication clear dot1x bonded-period on page 18-436
set dot1x bonded-period on page 18-440
Reauthentication set dot1x reauth on page 18-443
set dot1x reauth-max on page 18-443
clear dot1x reauth-max on page 18-437
set dot1x reauth-period on page 18-444
clear dot1x reauth-period on page 18-437
Retransmission set dot1x max-req on page 18-441
clear dot1x max-req on page 18-436
Quiet Period and
Timeouts
set dot1x quiet-period on page 18-442
clear dot1x quiet-period on page 18-437
set dot1x timeout auth-server on page 18-444
clear dot1x timeout auth-server on page 18-438
set dot1x timeout supplicant on page 18-445
clear dot1x timeout supplicant on page 18-438
Settings, Active Clients,
and Statistics
show dot1x on page 18-447