Operation Manual

RADIUS, LDAP, and Server Groups Commands

17 – 439

describes the fields that can appear in the show radius output.

Table 17– 2. show radius Output

Field Description

Default values RADIUS default values for all parameters.

Server Name of each RADIUS server currently active.

IP Address IP address of each RADIUS server currently active.

Auth Port UDP port on the MX for transmission of RADIUS authorization and

authentication messages. The default port is 1812.

Acct Port UDP port on the MX for transmission of RADIUS accounting records.

The default is port 1813

Time Out Number of seconds the MX waits for a RADIUS server to respond

before retransmitting. The default is 5 seconds

Retry Number of times the MX switch retransmits a message before

determining a RADIUS server unresponsive. The default is 3 times

Dead Time Number of minutes the MX switch waits after determining a RADIUS

server is unresponsive before trying to reconnect with this server.

During the dead time, the RADIUS server is ignored by the MX. The

default is 0 minutes.

State Current state of each RADIUS server currently active:

❑ UP (operating)

❑ DOWN (unavailable)

Server Group Names of RADIUS server groups and member servers configured on the

MX.

RADIUS Dynamic Authorization

Configuration

If configured, dynamic authentication attributes are displayed.

Server Port The RADIUS server port configured for dynamic authorization.

Dynamic Author

Dynamic Author Clients The name of the DAC server

IP Address IP address of the DAC sever

Disconnect Disconnected clients

Change Author Enable or disable any changes in authorization

Replay Protect Enable or disable replay protection

Replay Win The length of time in seconds to allow for replay.