Operation Manual

RADIUS, LDAP, and Server Groups Commands
RADIUS, LDAP, and Server Groups Commands
17 – 437
Examples Use the following command to display information about LDAP configurations.
MX# show ldap
LDAP Servers Default Values
auth-port=389, timeout=5(s), deadtime=5(mn)
bind-mode=sasl-md5, mac-addr-format=hyphens
LDAP Servers
Flags: (state) U=up, D=down
(bind-mode) s=simple-auth, m=sasl-md5
(mac-format) h=hyphens, c=colons, o=one-hyphen, r=raw
Auth Time Deadtime Flags
Server IP address Port Out Conf:Rem s:bm FQDN
-------------- --------------- ---- ---- ---------- ----- ---------------------
techpubs 10.8.112.212 389 5 5 :0m U:mh trapeze.com
testldap 10.1.1.1 389 5 5 :0m U:mh
Server groups
techldap: testldap
Table 17– 1. show LDAP output
Field Description
Default values LDAP default values for all parameters.
Flags Indicates the following information:
❑ state - U=up , D=down
❑ bind-mode - s=simple-auth m=sasl-md5
❑ mac-format - h=hyphens, c=colons, o=one-hyphen, r=raw
Server Name of each LDAP server currently active.
IP Address IP address of each LDAP server currently active.
Auth Port UDP port on the MX for transmission of LDAP authorization and
authentication messages. The default port is 389.
Time Out Number of seconds the MX waits for a LDAP server to respond before
retransmitting. The default is 5 seconds
Dead Time Number of minutes the MX switch waits after determining a LDAP
server is unresponsive before trying to reconnect with this server.
During the dead time, the LDAP server is ignored by the MX. The
default is 0 minutes.
Flags Current state of each RADIUS server currently active:
❑ UP (operating)
❑ DOWN (unavailable)
FQDN The fully qualified domain name associated with the LDAP server.
Server Group Names of LDAP server groups and member servers configured on the
MX.
Server Port The RADIUS server port configured for dynamic authorization.