Operation Manual

RADIUS, LDAP, and Server Groups Commands

Mobility System Software Command Reference Guide

Version 7.3

17 – 436

History

Introduced in MSS 1.0.

Usage

You can optionally enable load balancing after assigning the server group members. If you

configure load balancing, MSS sends each AAA request to a separate server, starting with the

first one on the list and skipping unresponsive servers. If no server in the group responds, MSS

moves to the next method configured with set authentication and set accounting.

In contrast, if load balancing is not configured, MSS always begins with the first server in the list

and sends unfulfilled requests to each subsequent server in the group before moving on to the next

configured AAA method.

Examples

To enable load balancing between the members of server group shorebirds, type the

following command:

MX-20# set server group shorebirds load-balance enable

success: change accepted.

To disable load balancing between shorebirds server group members, type the following command:

MX-20# set server group shorebirds load-balance disable

success: change accepted.