Operation Manual

RADIUS, LDAP, and Server Groups Commands
Mobility System Software Command Reference Guide
Version 7.3
17 – 426
See Also
● set radius server on page 433
● show aaa on page 190
clear server group
Removes a RADIUS server group from the configuration, or disables load balancing for the group.
Syntax clear server group group-name [load-balance]
Defaults None.
Access Enabled.
History Introduced in MSS 1.0.
Usage Deleting a server group removes the server group from the configuration. However, the
members of the server group remain.
Examples To remove the server group sg-77 type the following command:
MX# clear server group sg-77
success: change accepted.
To disable load balancing in a server group shorebirds, type the following command:
MX# set server group shorebirds load-balance disable
success: change accepted.
See Also set server group on page 435
ldap-ping
Provides a diagnostic tool to enhance troubleshooting capabilities for LDAP servers on the
network.
Syntax ldap-ping [group server-group-name | server server-name]
Defaults None
Access Enabled
History Introduced in MSS 7.1
radping
Provides a diagnostic tool to enhance troubleshooting capabilities for RADIUS servers on the
network. The command sends an authentication request to the RADIUS server to determine if it
is offline.
group-name Name of a RADIUS server group configured to perform remote AAA services for MX
switches.
load-balance Ability of group members to share demand for services among servers.