Operation Manual

RADIUS, LDAP, and Server Groups Commands 17 – 421
17
RADIUS, LDAP, and Server Groups Commands
Use RADIUS commands to set up communication between an MX switch and groups of up to four
RADIUS servers for remote authentication, authorization, and accounting (AAA) of
administrators and network users. This chapter presents RADIUS commands alphabetically. Use
the following table to locate commands in this chapter based on their uses.
With MSS 7.1, LDAPv3 is now available as an authentication method. You can configure LDAP
servers, LDAP server groups, and LDAP load-balancing across LDAP servers.
Command Auditing
LDAP Servers clear ldap auth-port on page 422
clear ldap base-dn on page 422
clear ldap bind-mode on page 422
clear ldap deadtime on page 422
clear ldap mac-addr-format on page 422
clear ldap timeout on page 423
ldap-ping on page 426
set ldap on page 427
set ldap server on page 428
LDAP Server Groups set ldap server group on page 428
set ldap server group load-balance on page 429
RADIUS Client set radius client system-ip on page 431
set radius client system-ip on page 430
clear radius client system-ip on page 424
RADIUS Diagnostics radping on page 426
RADIUS Servers set radius on page 429
set radius client system-ip on page 430
set authorization dynamic on page 431
set radius das-port on page 431
set radius server on page 433
clear radius on page 423
clear radius server on page 425
show radius on page 438
Server Groups set server group on page 435
set server group load-balance on page 435
clear server group on page 426
RADIUS Proxy set radius proxy client on page 432
set radius proxy port on page 433
clear radius proxy client on page 425
clear radius proxy port on page 425