Operation Manual

Security ACL Commands
Security ACL Commands
15 – 405
● set security acl on page 15-395
show security acl map
Displays the VLANs, ports, and virtual ports on the MX that a security ACL is assigned.
Syntax show security acl map acl-name
Defaults None.
Access Enabled.
History
Examples
The following command displays the port to which security ACL acl_111 is mapped:
MX# show security acl map acl_111
ACL acl_111 is mapped to:
Port 4 in
See Also
● clear security acl map on page 15-393
● set security acl map on page 15-400
● show security acl on page 15-402
show security acl resource-usage
Displays statistics about the resources used by security ACL filtering on the MX.
Syntax show security acl resource-usage
Defaults None.
Access Enabled.
History Introduced in MSS Version 1.0.
Usage Use this command with the help of the Trapeze Technical Assistance Center (TAC) to
diagnose an ACL resource problem. (To contact TAC, see “Contacting the Technical
Assistance Center” on page 1–1.)
Examples To display security ACL resource usage, type the following command:
MX# show security acl resource-usage
ACL resources
Classifier tree counters
------------------------
Number of rules : 2
Number of leaf nodes : 1
Stored rule count : 2
Leaf chain count : 1
acl-name Name of an existing security ACL to display static mapping. ACL names must start
with a letter and are case-insensitive.
MSS Version 1.0 Command introduced
MSS Version 1.1 ACL names changed from case-sensitive to case-insensitive