Operation Manual

IGMP Snooping Commands
Mobility System Software Command Reference Guide
Version 7.3
14 – 382
Syntax set igmp rv num [vlan vlan-id]
Defaults The default robustness value for all VLANs is 2.
Access Enabled.
History Introduced in MSS Version 1.0.
Examples The following example changes the robustness value on VLAN orange to 4:
MX# set igmp rv 4 vlan orange
success: change accepted.
See Also
● set igmp oqi on page 14-378
● set igmp qi on page 14-379
● set igmp qri on page 14-380
set igmp version
Configures the version of IGMP used on a VLAN.
Syntax set igmp version {1 | 2} vlan [vlan-id | all]
Defaults None
Access Enabled
History Introduced in MSS Version 7.0.
show igmp
Displays IGMP configuration information and statistics for one VLAN or all VLANs.
Syntax show igmp [vlan vlan-id]
Defaults None.
Access All.
History Introduced in MSS Version 1.0.
Examples The following command displays IGMP information for VLAN orange:
MX# show igmp vlan orange
VLAN: orange
IGMP is enabled
Proxy reporting is on
Mrouter solicitation is on
Querier functionality is off
Configuration values: qi: 125 oqi: 300 qri: 100 lmqi: 10 rvalue: 2 Multicast
num Robustness value. You can specify a value from 2 through 255. Set the robustness
value higher to adjust for more traffic loss.
vlan vlan-id
VLAN name or number. If you do not specify a VLAN, MSS changes the robustness
value for all VLANs.
vlan
vlan-id
VLAN name or number. If you do not specify a VLAN, MSS displays IGMP
information for all VLANs.