Operation Manual

IGMP Snooping Commands 14 – 375
14
IGMP Snooping Commands
Use Internet Group Management Protocol (IGMP) snooping commands to configure and manage
multicast traffic reduction on an MX. This chapter presents IGMP snooping commands
alphabetically. Use the following table to locate commands in this chapter based on their use.
clear igmp statistics
Clears IGMP statistics counters on one VLAN or all VLANs on an MX and resets them to 0.
Syntax clear igmp statistics [vlan vlan-id]
Defaults None.
Access Enabled.
History Introduced in MSS Version 1.0.
Examples The following command clears IGMP statistics for all VLANs:
MX# clear igmp statistics
IGMP statistics cleared for all vlans
IGMP Snooping State set igmp mrouter on page 14-377
show igmp on page 14-382
Proxy Reporting set igmp proxy-report on page 14-379
Pseudo-querier set igmp querier on page 14-380
show igmp querier on page 14-386
Timers set igmp qi on page 14-379
set igmp oqi on page 14-378
set igmp qri on page 14-380
set igmp lmqi on page 14-376
set igmp rv on page 14-381
Router Solicitation set igmp mrsol on page 14-377
set igmp mrsol mrsi on page 14-378
Multicast Routers set igmp mrouter on page 14-377
show igmp mrouter on page 14-385
Multicast Receivers set igmp receiver on page 14-381
show igmp receiver-table on page 14-387
Statistics show igmp statistics on page 14-388
clear igmp statistics on page 14-375
vlan
vlan-id
VLAN name or number. If you do not specify a VLAN, IGMP statistics are cleared for
all VLANs.