Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 363
● set service-profile static-cos on page 12-311
● set service-profile tkip-mc-time on page 12-312
● set service-profile transmit-rates on page 12-312
● set service-profile user-idle-timeout on page 12-314
● set service-profile web-portal-form on page 12-316
● set service-profile web-portal-session-timeout on page 12-318
● set service-profile wep active-multicast-index on page 12-319
● set service-profile wep active-unicast-index on page 12-320
● set service-profile wep key-index on page 12-320
● set service-profile wpa-ie on page 12-321
show service-profile cac session
Displays current session counts on all MPs using the specified service profile, when session-based
CAC is enabled.
Syntax show service-profile profile-name cac session
Defaults None.
Access Enabled.
History Introduced in MSS Version 6.0.
Examples The following command displays information about session counts for service profile
sp1:
MX# show service-profile sp1 cac session
Service Profile sp1
CAC Mode SESSION
Max Sessions 14
Table 12– 20 describes the fields in displayed by the show service-profile cac session
command.
See Also
● set service-profile cac-mode on page 12-290
● set service-profile cac-session on page 12-291
profile-name Displays information about the named service profile.
Table 12– 20. Output for show service-profile cac session
Field Description
Service Profile Name of the service profile
CAC Mode CAC mode, either SESSION or NONE
Max Sessions The number of CAC sessions available on MPs managed by this service
profile.