Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 353
See Also
● show ap connection on page 12-349
● show ap global on page 12-351
show load-balancing group
Displays an RF load balancing group’s member radios and current load for each radio.
Syntax show load-balancing group {group-name | all | [ap apnum radio {1 | 2}]}
Defaults None.
Access Enabled.
History
Usage Use this command to display information about the RF load-balancing groups configured
on the MX and the individual MP radios in the load-balancing groups.
Examples The following command displays information about the MP radios that are in the same
group as radio 1 on MP 3:
MX# show load-balancing group ap 3 radio 1
Radios in the same load-balancing group as: ap3/radio1
--------------------------------------------------
IP address AP Radio Overlap
------------------ ---- ----- -------
10.2.28.200 3 1 100/100
The following command displays information about RF load balancing group blue:
Table 12– 16. Output for show ap unconfigured
Field Description
Serial Id Serial ID of the MP.
Model MP model number.
IP Address IP address of the MP. This is the address that the MP receives from a
DHCP server. The MP uses this address to send a Find MX message to
request configuration information from MX switches. However, the MP
cannot use the address to establish a connection unless the MP first
receives a configuration from an MX.
Port Port number on which this MX received the MP Find MX message.
VLAN VLAN that this MX received the MP Find MX message.
group-name Name of an RF load-balancing group configured on the MX.
all Displays information for every load-balancing group that has a radio on this
MX as a member.
apnum
Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
radio {1 | 2} Shows status information for a radio on an MP. This option displays
information about radios in the same group as the specified radio.
Version 6.0 Command introduced.
Version 6.2 Added index value range of 1 to 9999.