Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 352
See Also
● set ap on page 5-52
● set ap bias on page 12-234
● show ap config radio on page 12-328
● show ap connection on page 12-349
● show ap unconfigured on page 12-352
show ap unconfigured
Displays Distributed MPs that are physically connected to the network but that are not
configured on any MX switches.
Syntax show ap unconfigured
Defaults None.
Access Enabled.
History
Usage This command also displays an MP that is directly connected to an MX, if the MX port
connected to the MP is configured as a network port instead of an MP access port, and if the
network port is a member of a VLAN.
If a Distributed MP is configured on an MX, the MP can appear in the output until the MP is able
to establish a connection with an MX in a Mobility Domain. After the MP establishes a connection,
the entry for the MP ages out and no longer appears in the command output.
Entries in the command output table age out after two minutes.
Examples The following command displays information for two Distributed MPs that are not
configured:
MX# show ap unconfigured
Total number of entries: 2
Serial Id Model IP Address Port Vlan
----------- ------ --------------- ---- --------
0333001287 MP-241 10.3.8.54 5 default
0333001285 MP-252 10.3.8.57 7 vlan-eng
Table 12– 16 describes the fields in this display.
MX IP Address System IP address of the MX on which the Distributed MP is
configured. A separate row of output is displayed for each MX on
which the Distributed MP is configured.
Bias Bias of the MX for the MP:
❑ High
❑ Low
Version 2.0 Command introduced.
Version 6.0 Option dap removed.
Table 12– 15. Output for show ap global (continued)
Field Description