Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 351
show ap global
Displays connection information for Distributed MPs configured on an MX .
Syntax show ap global [apnum | serial-id serial-ID]
Defaults None.
Access Enabled.
History
Usage
Connections are shown only for the Distributed MPs configured on the MX that you enter
the command, and only for the Mobility Domain of the MX.
To show information only for Distributed MPs that have active connections, use the show ap
connection command.
Examples The following command displays connection information for all the Distributed MPs
configured on an MX:
MX# show ap global
Total number of entries: 8
AP Serial Id MX IP Address Bias
--- ----------- --------------- ----
1 11223344 10.3.8.111 HIGH
- 11223344 10.4.3.2 LOW
2 332211 10.3.8.111 LOW
- 332211 10.4.3.2 HIGH
17 0322100185 10.3.8.111 HIGH
- 0322100185 10.4.3.2 LOW
18 0321500120 10.3.8.111 LOW
- 0321500120 10.4.3.2 HIGH
Table 12– 15 describes the fields in this display.
apnum Index value that identifies the MP on the MX. You can specify a value
from 1 to 9999.
serial-id serial-ID MP access point serial ID.
Version 2.0 Command introduced.
Version 6.0 Option dap removed.
Version 6.2 Added index value range from 1 to 9999.
Table 12– 15. Output for show ap global
Field Description
AP ID you assigned to the Distributed MP.
Note: AP numbers are listed only for Distributed MPs configured on
this MX switch. If the field contains a hyphen ( - ), the Distributed MP
configuration displayed in the row of output is on another MX switch.
Serial Id Serial ID of the Distributed MP.