Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 350
This command provides information only if the Distributed MP is configured on the MX where you
entered the command. The MX does not need to be the one that booted the MP, but it must have
the MP in the configuration. Also, the MX that booted the MP must be in the same Mobility
Domain as the MX where you entered the command.
If a Distributed MP is configured on this MX (or another MX in the same Mobility Domain) but
does not have an active connection, the command does not display information for the MP. To
show connection information for Distributed MPs, use the show ap global command on one of
the switches where the MPs are configured.
Examples The following command displays information for all Distributed MPs configured on this
MX switch that have active connections:
MX# show ap connection
Total number of entries: 2
AP Serial Id AP IP Address MX IP Address
--- ----------- --------------- ---------------
2 112233 10.10.2.27 10.3.8.111
4 0333000298 10.10.3.34 10.3.8.111
The following command displays connection information specifically for a Distributed MP with
serial ID 223344:
MX# show ap connection serial-id 223344
Total number of entries: 1
AP Serial Id AP IP Address MX IP Address
--- ----------- --------------- ---------------
9 223344 10.10.4.88 10.9.9.11
Table 12– 14 describes the fields in this display.
See Also
● show ap config radio on page 12-328
● show ap global on page 12-351
● show ap unconfigured on page 12-352
Table 12– 14. Output for show ap connection
Field Description
AP ID assigned to the Distributed MP.
If the connection is configured on another MX, this field contains a
hyphen ( - ).
Serial Id Serial ID of the Distributed MP.
AP IP Address IP address assigned by DHCP to the Distributed MP.
MX IP Address System IP address of the MX that the MP has an active connection.
This is the MX that the MP used for booting and configuration and is
using for data transfer.