Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 349
show ap connection
Displays the system IP address of the MX that booted a Distributed MP.
Syntax show ap connection [apnum | serial-id serial-ID]
Defaults None.
Access Enabled.
History I
Usage The serial-id parameter displays the active connection for the specified Distributed MP
even if that MP is not configured on this MX. If you instead use the command with the apnum
parameter or without a parameter, connection information is displayed only for Distributed MPs
configured on this MX.
Table 12– 13. Output for show ap boot-configuration
Field Description
AP MP number.
IP address Whether static IP address assignment is enabled for this Distributed
MP.
VLAN Tag Whether the Distributed MP is configured to use a VLAN tag.
Switch Whether the Distributed MP is configured to use a manually specified
MX as the boot device.
Mesh Whether WLAN mesh services are enabled for this MP.
IP address The static IP address assigned to this Distributed MP.
Netmask The subnet mask assigned to this Distributed MP.
Gateway The IP address of the default gateway assigned to this Distributed MP.
VLAN Tag The VLAN tag that the Distributed MP is configured to use (if any).
Switch IP The IP address of the MX that this Distributed MP is configured to use
as its boot device (if any).
Switch Name The name of the MX that this Distributed MP is configured to use as
the boot device (if any).
DNS IP The IP address of the DNS server that the Distributed MP uses to
resolve the name of the MX used as the boot device.
Mesh SSID The WLAN mesh services SSID this MP is configured to use (if any)
Mesh PSK The preshared key (PSK) the MP uses for authentication with a Mesh
Portal AP (if any).
apnum Index value that identifies the MP on the MX. You can specify a value
from 1 to 9999.
serial-id serial-ID MP access point serial ID.
Version 2.0 Command introduced.
Version 6.0 Option dap removed.
Version 6.2 Added index value range of 1 to 9999.