Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 348
● set radio-profile auto-tune 11a-channel-range on page 12-260
● set radio-profile auto-tune channel-holddown on page 12-261
● set radio-profile auto-tune channel-interval on page 12-262
● set radio-profile auto-tune power-config on page 12-264
● set radio-profile auto-tune power-interval on page 12-264
● show auto-tune attributes on page 12-345
● show radio-profile on page 12-354
show ap boot-configuration
Displays information about the static IP address configuration (if any) on a Distributed MP.
Syntax show ap boot-configuration apnum
Defaults None.
Access Enabled.
History I
Examples The following command displays static IP configuration information for Distributed MP
1:
MX# show ap boot-configuration 1
Static Boot Configuration
AP: 7
IP Address: Disabled
VLAN Tag: Disabled
Switch: Disabled
Mesh: Disabled
IP Address:
Netmask:
Gateway:
VLAN Tag:
Switch IP:
Switch Name:
DNS IP:
Mesh SSID:
Mesh PSK:
Table 12– 6 describes the fields in this display.
apnum Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
Version 4.2 Command introduced.
Version 6.0 Option dap removed.
Field Mesh added
Field Mesh SSID added
Field Mesh PSK added
Version 6.2 Added index value range from 1 to 9999.