Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 345
History
Examples
The following command displays information about the VLANs switched by AP 7:
MX# show ap vlan 7
AP 7:
VLAN Name Mode Port Tag
---- ---------------- ---- ---------------- ----
1 default local 1 none
2 red local 1 2
radio_1 20
radio_1 21
radio_2 22
4 green local 1 4
radio_1 23
5 yellow tunnel mx_tun 5
radio_1 24
Table 12– 4 describes the fields in the show ap vlan output.
See Also
● set ap local-switching mode on page 12-244
● set vlan-profile on page 6-75
show auto-tune attributes
Displays the current values of the RF attributes RF Auto-Tuning uses to decide whether to change
channel or power settings.
Syntax show auto-tune attributes [ap apnum [radio {1 | 2| all}]]
Version 6.0 Command introduced.
Version 6.2 Introduced index value range of 1 to 9999.
Version 7.0 Added all option.
Table 12– 10. Output for show ap vlan
Field Description
VLAN VLAN number.
Name VLAN name
Mode Whether packets for the VLAN are locally switched by the MP, or are
tunneled to an MX, which places them on the VLAN.
Port The port(s) through which VLAN traffic is sent.
TAG VLAN tag value. If the interface is untagged, none is displayed in the
TAG field.
apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
radio 1 Shows RF attribute information for radio 1.
radio 2 Shows RF attribute information for radio 2. (This option does not apply to
single-radio models.)
radio all Shows RF attribute information for both radios.