Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 344
show ap vlan
Displays information about locally switched or tunneled VLANs.
Syntax show ap vlan apnum
Defaults None.
Access All.
IP Address
❑ IP address of the MP. The address is assigned to the MP by a DHCP server.
❑ VLAN assigned to the MP.
Note: This field is applicable only if the MP is configured on the MX as a
Distributed MP.
Port 1 link:
❑ Status
❑ Configured duplex speed
❑ PoE type
Port 2 link:
❑ Stauts
❑ Configured duplex speed
❑ PoE type and status
State: Operational status flags for the MP.
For flag definitions, see the key in the command output.
Uptime Amount of time since the MP booted using this link.
Radio 1 State, channel, and power information for radio 1:
❑ Radio type — 802.11a, 802.11b, 802.11g, 802.11na, or 802.11ng
❑ The state can be D (disabled) or E (enabled).
❑ Operational channel — Current channel for radio operations.
❑ Operational power — The power level at which the radio is currently
operating.
❑ Load balanced — Enabled or disabled.
❑ Current load — The load on this radio relative to the load balancing group
average or target load.
❑ RFID reports — Status of AeroScout asset tag support.
• Active—The AeroScout Engine has enabled the tag report mode on the
MP.
• Inactive—The AeroScout Engine has not enabled, or has disabled, the
tag report mode on the MP.
This field is displayed only if the rfid-mode option is enabled on the
radio profile that manages the radio.
❑ BSSID, SSID — The base MAC address of the radio and the SSIDs
configured on the radio.
Radio 2 State, channel, and power information for radio 2. See Radio 1 for more
information.
apnum Index value that identifies the MP on the MX. You can specify
a value from 1 to 9999.
all Displays all MPs on a VLAN.
Table 12– 9. Output for show ap status verbose
Field Description