Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 341
History
Examples
The following command displays the status of an MP access point:
Version 1.0 Command introduced.
Version 1.1 Radio type fields indicate when 802.11b protection is enabled on an 802.11b/g
radio.
Version 2.0
❑ Option dap added for Distributed MPs.
❑ Option all added.
❑ IP-addr field added for Distributed MPs.
❑ The dual-homed field was removed. (This field was located on the same line as the
Link field.)
Version 3.0
❑ in boot field removed.
❑ operational channel field added
❑ operational power field added
❑ bssid and ssid fields added
Version 3.2 True base MAC addresses of radios are displayed. Previously, the base MAC
address displayed for a radio was the true base MAC address plus 2.
Note that a radio’s base MAC address is also used as the BSSID of the first
SSID configured on the radio.
Version 4.0
❑ New option added: terse
❑ New option added for show dap status: all
❑ New field added: fingerprint
❑ MP-MX security status added to State field
Note: The fingerprint field and security state apply to the display for Distributed MPs
only.
Version 4.1
❑ External antenna information added after the radio state information, to indicate
when an antenna has been detected and to indicate the configured antenna model
number.
❑ Auto flag added to indicate operational channel or power settings that are
configured by RF Auto-Tuning.
Version 4.2 Radar Scan and Radar Detected flags added to indicate when the Dynamic
Frequency Selection (DFS) feature is scanning for radar or has stopped
transmitting due to detected radar. The flags apply to 802.11a radios only,
and only for country codes where DFS is used.
Version 5.0 RFID Reports field added.
Version 6.0 Option dap removed.
load balance field added
current load field added
Version 6.2 Added index value range of 1 to 9999 for MPs.
Version 7.0 Reformatted output to accomodate 802.11n and cluster configuration. Option
terse removed. Option verbose added. Added status as up or down.
Version 7.1 Added cluster to the options.