Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 340
Examples The following command mesh link information for AP 7:
MX# show ap mesh-links 7
AP: 7 IP-addr: 1.1.1.3
Operational Mode: Mesh-Portal
Downlink Mesh-APs
-------------------------------------------------
BSSID: 00:0b:0e:17:bb:3f (54 Mbps)
packets bytes
TX: 307 44279
RX: 315 215046
Table 12– 7 describes the fields in the show ap mesh-links output.
See Also
● set ap boot-configuration mesh ssid on page 12-239
● set service-profile mesh on page 12-299
show ap status
Displays MP access point and radio status information.
Syntax show ap status [[apnum | all | verbose | [radio {1 | 2}] cluster ip-addr]]
Defaults None.
Access Enabled.
Table 12– 7. Output for show ap mesh-links
Field Description
AP Identifier for the MP on the MX.
Name VLAN name
IP-addr IP address of the MP.
Operational Mode If this MP is a Mesh AP or a Mesh Portal AP
Downlink Mesh-APs Information about the Mesh APs associated with the Mesh Portal MP.
BSSID The BSSID of the Mesh AP.
TX The amount of traffic (packets and bytes) transmitted to the Mesh AP.
RX The amount of traffic (packets and bytes) received from the Mesh AP.
apnum
Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
all Shows status information for all directly attached MPs and all Distributed
MPs configured on the MX.
radio 1 Shows status information for radio 1.
radio 2 Shows status information for radio 2. (This option does not apply to
single-radio models.)
cluster Displays the status of the MPs in a cluster configuration.