Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 339
show ap group
Deprecated in MSS Version 6.0. To display information about RF load balancing, see show
load-balancing group on page 12-353.
show ap mesh-links
Displays information about the links an MP has to Mesh APs and Mesh Portal APs.
Syntax show ap mesh-links apnum
Defaults None.
Access All.
History
RxAlignErrs Number of received frames that were both misaligned and contained a
CRC error.
RxShortFrames Number of received frames that were shorter than the minimum
frame length.
RxCrcErrors Number of received frames that were discarded due to CRC errors.
RxOverruns Number of frames known to be lost due to a temporary lack of
hardware resources.
RxDiscards Number of frames known to be lost due to a temporary lack of software
resources.
TxGoodFrames Number of frames transmitted properly on the link.
TxSingleColl Number of transmitted frames that encountered a single collision.
TxLateColl Number of frames that were not transmitted because they
encountered a collision outside the normal collision window.
TxMaxColl Number of frames that were not transmitted because they
encountered the maximum allowed number of collisions. Typically,
this occurs only during periods of heavy traffic on the network.
TxMultiColl Number of transmitted frames that encountered more than one
collision.
TxUnderruns Number of frames that were not transmitted or retransmitted due to
temporary lack of hardware resources.
TxCarrierLoss Number of frames transmitted despite the detection of a deassertion of
CRS during the transmission.
TxDeferred Number of frames deferred before transmission due to activity on the
link.
apnum Index value that identifies the MP on the MX. You can specify
a value from 1 to 9999.
Version 6.0 Command introduced.
Version 6.2 Added index value range from 1 to 9999.
Table 12– 6. Output for show ap etherstats (continued)
Field Description