Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 336
History
Examples The following command displays FDB entries for AP 7:
MX# show ap fdb 7
AP 7:
# = System Entry. $ = Authenticate Entry
VLAN TAG Dest MAC/Route Des [CoS] Destination Ports
---- ---- ------------------ ----- -----------------
4095 4095 00:0b:0e:00:ca:c1 # CPU
4095 0 00:0b:0e:00:04:0c eth0
Table 12– 4 describes the fields in the show ap fdb output.
See Also
● set ap local-switching mode on page 12-244
● set vlan-profile on page 6-75
show ap qos-stats
Displays statistics for MP forwarding queues.
Syntax show ap qos-stats [apnum] [clear]
Defaults None.
Access Enabled.
Version 6.0 Command introduced.
Version 6.2 Added index value range of 1 to 9999.
Table 12– 4. Output for show ap fdb
Field Description
VLAN VLAN number.
TAG VLAN tag value. If the interface is untagged, the
TAG field is blank.
Dest MAC/Route Des MAC address of this forwarding entry’s
destination.
CoS Type of entry. The entry types are explained in the
first row of the command output.
Note: This Class of Service (CoS) value is not
associated with MSS quality of service (QoS)
features.
Destination Ports MX port associated with the entry. An MX sends
traffic to the destination MAC address through
this port.
apnum Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
clear Clears the counters after displaying their current values.