Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 330
See Also
● set ap on page 5-52
● set port type ap on page 5-59
● set ap bias on page 12-234
● set ap fingerprint on page 12-242
● set ap group on page 12-243
● set ap name on page 12-246
● set ap upgrade-firmware on page 12-257
● set ap radio mode on page 12-253
● set ap radio antennatype on page 12-247
● set ap radio channel on page 12-249
● set ap radio radio-profile on page 12-254
● set ap radio tx-power on page 12-254
● show ap connection on page 12-349
● show ap global on page 12-351
● show ap unconfigured on page 12-352
● show radio-profile on page 12-354
show ap counters
Displays MP access point and radio statistics counters.
Syntax show ap counters apnum [radio {1 | 2}]
auto-tune max-power Maximum power level the RF Auto-Tuning feature can set on the
radio.
❑ The value default means RF Auto-Tuning can set the power up to the
maximum level allowed for the country of operation.
❑ A specific numeric value means you or another administrator set the
maximum value.
load-balance-group Names of the RF load-balancing groups to which the MP belongs. If the
value is None, the MP does not belong to any load balancing groups.
Note: This field is displayed only if the MP is a member of a group.
load-balance-enable If RF load balancing is enabled for this MP.
force-rebalance If the MP radio disassociates the client sessions and rebalances them
whenever a new MP radio is added to the RF load balancing group.
local-switching If local packet switching is enabled for the MP.
vlan-profile The VLAN profile the MP uses for local packet switching, indicating
which VLANs are locally switched.
apnum
Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
Table 12– 1. Output for show ap config (continued)
Field Description