Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 329
location:
contact:
Radio 1: type: 802.11g, mode: disabled, channel: dynamic
tx pwr: 18, profile: default
auto-tune max-power: default,
load-balance-group: ,
load-balance-enable: YES,
force-rebalance: NO,
local-switching: disabled, vlan-profile: default
Table 12– 1 describes the fields in this display.
Table 12– 1. Output for show ap config
Field Description
Port MX port number to which the MP is connected, if specified for the MP.
AP Index number that identifies the MP on the MX.
serial-id Serial number on the MP.
AP model MP model number.
bias Bias of the MX connection to the MP:
❑ High
❑ Low
name MP access point name, if configured.
upgrade-firmware State of the firmware upgrade option:
❑ YES (automatic upgrades are enabled)
❑ NO (automatic upgrades are disabled)
force-image-download State of the option to force the MP to download a software image from
the MX instead of loading a locally stored image on the MP.
communication timeout
location Location information for the MP.
contact Contact information for the MP.
Radio Radio number. The information listed below this field applies
specifically to the radio.
type Radio type:
❑ 802.11a
❑ 802.11b
❑ 802.11g
mode Radio state:
❑ Enabled
❑ Disabled
channel Channel number.
antennatype External antenna model, if applicable.
tx pwr Transmit power, in dBm.
profile Radio profile that manages the radio. Until you assign the radio to a
radio profile, MSS assigns the radio to the default radio profile.