Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 328
show ap config radio
Displays global and radio-specific settings for an MP.
Syntax show ap apnum config [port-list [radio {1 | 2}]]
Defaults None.
Access Enabled.
History
Usage
MSS lists information separately for each MP.
Examples The following example shows configuration information for MP 2:
MX# show ap config 2
AP 2: serial-id: 123456789, AP model: MP-372, bias: high, name: AP02
upgrade-firmware: YES
force-image-download: NO
communication timeout: 10
apnum
Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
radio 1 Shows configuration information for radio 1.
radio 2 Shows configuration information for radio 2. (This option
does not apply to single-radio models.)
Version 1.0 Command introduced.
Version 1.1 New field added: load balancing group.
Version 2.0
❑ Option dap added for Distributed MPs.
❑ Dap and Serial-Id fields added to display for Distributed MPs.
❑ The load balancing group field is displayed only if the MP is a member of a group.
Version 2.1 New field, antennatype, to list the external antenna model configured for the
802.11b/g radio in an MP-262.
Version 3.0
❑ New fields added:
• auto-tune max-power
• auto-tune min-client-rate
• auto-tune max-retransmissions
❑ beacon field removed
Version 4.0
❑ New field added: fingerprint
Note: This field applies to the display for Distributed MPs only.
Version 5.0
❑ Field force-image-download added:
❑ Field auto-tune min-client-rate removed.
❑ Field auto-tune max-retransmissions removed.
❑ Field location added.
❑ Field contact added.
Version 6.0
❑ Option dap removed.
❑ Field communication timeout added.
❑ Field load-balance-enable added.
❑ Field force-rebalance added.
❑ Field local-switching added.
❑ Field vlan-profile added.
Version 6.2 Added index value range from 1 to 9999.