Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 326
● set security acl on page 15-395
show ap acl resource-usage
Displays statistics about the resources used by security ACL filtering on the MP.
Syntax show ap acl resource-usage apnum
Defaults None.
Access Enabled.
History
Usage
Use this command with the help of the Trapeze Technical Assistance Center (TAC) to
diagnose an ACL resource problem.
Examples To display security ACL resource usage for MP 7, type the following command:
MX# show ap acl resource-usage 7
AP 7 mapped ACL counters
--------------------------------------------
Number of rule groups : 0
Number of rules : 0
Number of maps : 0
show ap arp
Displays the ARP table for a specified MP.
Syntax show ap arp apnum
Defaults None.
Access All.
History
Examples The following command displays ARP entries for AP 7:
MX# show ap arp 7
AP 7:
Host HW Address VLAN State Type
------------------------------ ----------------- ----- -------- -------
apnum Index value that identifies the MP on the MX. You can specify
a value from 1 to 9999.
Version 6.0 Command introduced.
Version 6.2 Added index value range from 1 to 9999.
apnum Index value that identifies the MP on the MX. You can specify a value from 1 to
9999.
Version 6.0 Command introduced.
Version 6.2 Added index value range from 1 to 9999.