Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 325
History I
Usage For MSS to count hits for a security ACL, you must specify hits in the set security acl
commands that define ACE rules for the ACL.
Examples To display the security ACL hits on MP 7, type the following command:
MX# show ap acl hits 7
ACL hit-counters for AP 7
Index Counter ACL-name
----- -------------------- --------
1 0 acl_2
2 0 acl_175
3 916 acl_123
See Also
● set security acl hit-sample-rate on page 15-401
● set security acl on page 15-395
show ap acl map
Displays a summary of the security ACLs mapped on an MP.
Syntax show ap acl map apnum
Defaults None.
Access Enabled.
History I
Usage This command lists only the ACLs that have been mapped on the specified MP. To list all
committed ACLs, use the show security acl info command. To list ACLs that have not yet been
committed, use the show security acl editbuffer command.
Examples To display a summary of the security ACLs mapped on MP 7, type the following
command:
MX# show ap acl map 7
ACL Type Class Mapping
---------------------------- ---- ------ -------
acl_123 IP Static In
acl_133 IP Static In
acl_124 IP Static
See Also
● clear security acl on page 15-391
● commit security acl on page 15-394
Version 6.0 Command introduced.
Version 6.2 Added index value range of 1 to 9999.
apnum Index value that identifies the MP on the MX. You can specify a value from 1 to
9999.
Version 6.0 Command introduced.
Version 6.2 Added index value range of 1 to 9999.